Have Digiprog iii to adjust the mileage on 2008 Ford escape, what’s the correct pinouts?
Pinout:
This picture of pinout uses cable st48.
Question: I used the 48 but didn’t work at start. so I switch to 35. not a lot info on those dashs. However, after trying to adjust the mileage on 2008 Ford escape with the wrong pinouts, dash is only displaying yellow airbag and the car doesn’t start.
pulling the OBD codes it showing Theft detected vehicle immobilized. P1260
Answer:
Problem is you used cable 35 instead 48, cable 35 uses 12 v instead of 5 volts
MCU and voltage regulator.
if cheap enough start with order set of clocks.
in meantime, get ready to remove quick, plug dash back in see if any part of board gets hot
Update:
Just highlighting some updates for people that might have the same problem.
after frying the dashboard with wrong pinouts, I installed another used dashboard and immo was flashing. I reset the immo with the keys using Autel. now the car started again.
how can I adjust the new dash to the original mileage. I see two pinouts bellow:
to mention that my 35 and 48 cables are Chinese so wiring color is deferent might help to point out the location with pinout number in digiprog 3.
Last but not least:
This has been posted dozens of times if you did a search, but has some extra info.
First thing you do is modify the cables to the right colors.
Second thing you do is not substitute cables.
http://www.mileageprogrammer.com/digiprog-3-cable-pinouts-all-here/
