Question:
I want to use YANHUA Digimaster 3 to correct the mileage. When I read the 8-pin chip, an error occurs: (1E0F) Not found device. How can I solve it?
Answer:
We have mentioned the (1E0F) error many times before. There are only two reasons for the prompt that the device cannot be found: one is poor welding, and the other is that the adapter is short-circuited. You need to check each one.
If it is a welding problem, you can re-solder and try again.
If it is an adapter problem, the OBP adapter has two pads. Try another pad.
If the same error is still prompted, you can only replace a new OBP adapter.
