Yanhua Mini ACDP + Module 30 is able to do VW/Audi DQ500(0BH Continental) gearbox mileage correction. For users who already owned module 19 or module 25 can open the Mileage Correction License directly. Read this guide to learn the procedure.
Accessories Required
TCM
ACDP Programmer
0DE interface board
DB15-LAN adapter
TCU cable
How to connect?
- Connect the 0DE interface board toDB15-LAN adapter, short circuit the CAN resistor of DB15-LAN adapter to the “CAN-R” end.
- Unplug the original gearbox plug, install the 0DE interface board tovehicle TCU plug. Connect to the ACDP device and power it up.
How to adjust VW/Audi 0BH Continental mileage?
Connect ACDP to a stable WiFi.
Mini ACDP>> VW >> Gearbox mileage correction >> Audi >> DQ500(0BH CONTINENTAL) >> Identify
Make sure using the ACDP power(voltage+ 12V, current > = 2.5A).
Confirm connect the ACDP with gearbox.
Check the mileage and time of the original TCU.
Mileage: 1000km, system run time: 250h, click “OK”.
Identify finish.
Mileage correction(auto mode) >> OK >> Continue >>Confirm the system info, OK >>Click “OK” to save the EEPROM data.
Enter the new mileage: 14000km
Click “OK”.
*Attention: Ready to write chip data, please don’t cut the power nor pull out the device during the programming! Click “Continue”.
Correct mileage finish.
Time correction(auto mode) >> OK >> Continue >>Confirm system info, OK>> Save EEPROM
Enter the new time hours: 350h
OK >> Continue
Correct time finish.
Go back to identify system info again.
The mileage and system run timewere changed.
This is how to do VW/Audi0BH Continental odometer correction with Yanhua ACDP.
