Several boards were in those clusters Digiprog iii will work most of them were hc912 mcus.
Digiprog will do them whether your writing them manually by hand or with another calc built into digi
if its a hc11 it will also work
Ford Expedition 2013 dash pictures attached:
the processor in that board is a hc912d60 mcu board
and according to tachosoft these are the mileage blocks
Car type: Ford Expedition – 68HC912D60 – 2003 year
The mileage is stored in the next lines:
0340: 4A 38 xx xx xx xx xx xx xx xx xx xx xx xx xx xx
0350: 4A 38 xx xx xx xx xx xx xx xx xx xx xx xx xx xx
0360: 4A 38 xx xx xx xx xx xx xx xx xx xx xx xx xx xx
0370: 4A 38 xx xx xx xx xx xx xx xx xx xx xx xx xx xx
0380: 4A 38 xx xx xx xx xx xx xx xx xx xx xx xx xx xx
where the next bytes:
4A 38 – is a mileage
Try this connection.
yes thats what you needed for wiring under digiprog3
goto eeprom
then page down to mcu
then select 9s12 and 9s12 4k
i believe its the 4k you need for d60
use ST48 which is 5volt St51 is 12volt when powering board instead of just mcu
wire how clusters pic is which is your life saver knowing where to grab reset on board
then handwrite mileage block
or make your life alot easier and order a usaprog or datasmart dsp3 something else
but digiprog will do as well.
