Though DigiProg 3 is designed to work stand-alone for the sake of the large screen display, still some others turn to like PC operation. Is it possible to make DigiProg 3 odometer correction tool (current V4.94 version) connected to PC? Someone has tested it work and obdexpress.co.uk here is glad to share.
NOTE: We are not responsible for the damage.
First of all, dissemble the digiprog 3 v4.94 firmware PCB board
If you find your DP3 PCB is missing a FTDI chip marked red below, solder it with correct FTDI chip
With the FTDI FT232BL chip, you can connect digiprog3 with computer/laptop. The FTDI
chip acts as the driver in device manager. You will not be able to transfer your read eeprom dumps to and from pc/laptop etc. You can save dumps to pc with it.
Solder the FTDI chip and works perfect. No problem with the drivers all installed by themselves.
Connect digiprogiii mileage correction master with PC and start operating.
http://www.obdexpress.co.uk/wholesale/digiprog-iii-3-digiprog3-d-odometer-master-programmer.html